How To Remove A Manual Transmission
Topic: What's Required to Remove 4 Sp Transmission Transmission
in Forum: C3 Driveline Components
Already a Member? Click Here to Login
Non notwithstanding a Member? Click Hither to Register for Complimentary!
What's Required to Remove four Sp Manual Transmission (1/twenty)
10/5/08 9:24am
jp75vette
Old Member
Send Individual Message
Bloomfield Hills, MI - United states
Vette(south):
1975 Corvette coupe, 4 speed manual, 383 ci 9.5:1,Edelbrock dual airplane Air Gap intake, Alum Heads,Comp Cam, roller Rockers, PS,Lead,Tilt
Joined: 6/29/2008
Posts: 199
My four speed manual does not shift into 3rd gear, so effectually Thanksgiving I will park information technology for the winter and put it on jack stands. I desire to remove the manual and rebuild it during the winter. What is required to remove the transmission?
Our Sponsors help support C3VR
What's Required to Remove 4 Sp Manual Transmission (ii/20)
x/5/08 10:19am
rick d
Sometime Member
Send Private Message
williamston, NC - U.s.a.
Vette(due south):
1969 coupe, 350, m22 trans, ac, blackness on black,
Joined: 1/xix/2006
Posts: 353
not too hard to remove, general hand tools , a transmission jack or a proficient roller jack, if you are gonna replace the clutch assembly yous volition need a clutch alignment tool.You will need an actress set of hands and about a case of budlite,,brand certain yous take note of how information technology comes autonomously, and the set up of your shifter linkage, the members hither volition walk you thru information technology,, good luck rd
What'south Required to Remove 4 Sp Manual Manual (iii/20)
x/5/08 eleven:13am
basically as rick said... its non tooo overly complicated, basically you'll accept to remove the driveshaft(trust me on that, tried leavinig the differential end attached, not enough room to manuever the tranny out with information technology in, UNLESS you lot have a bolt in transmission crossmember, and then its a breeze), the shifter(after taking the tranny mountain you can drop the tranny down a little to get to the side of the shifter to take it off, and then take the linkages off), the tranny mount, and it would be eaiser to to accept the four bolts property the transmission to the bell housing then slide out the tranny to the rear then nose swoop out the front. Bellhousing is pretty straightforward at this indicate. As Rick said, do take notation(or even pictures with a digi cam) for the shifter linkage mainly. good luck, and when time comes nosotros can walk you lot through it.
______________
StingrayJim 
NCM Lifetime Member #1936
Stingray's '76���������������������������� StingrayJr's '78���������������������������Lil Ruby-red '94
(click each one to encounter a bigger version)
What'due south Required to Remove 4 Sp Transmission Transmission (4/20)
x/vi/08 ten:19am
VetteSpecialties
Former Member
Ship Individual Message
Mounds View, MN - USA
Vette(southward):
lxx LT1 coupe, 69 350 HP coupe, 69 390HP 427 coupe, 71 LS5 catechumen, 85 coupe, 93 coupe
Joined: v/24/2007
Posts: 1031
And, as has been repeated many times on this forum, the AIM has great diagrams.
Larry
What'due south Required to Remove 4 Sp Manual Transmission (5/20)
2/vii/09 1:13pm
jp75vette
Former Member
Send Private Message
Bloomfield Hills, MI - United states
Vette(s):
1975 Corvette coupe, 4 speed manual, 383 ci 9.5:1,Edelbrock dual plane Air Gap intake, Alum Heads,Comp Cam, roller Rockers, PS,PB,Tilt
Joined: half-dozen/29/2008
Posts: 199
Transmission is removed, thanks for the tips. The rebuild kit is in and now waiting for warmer weather to put it back. First accept to get new tunnel insulation in place. As well have to rivet in new clips every bit they are all gone.
What'southward Required to Remove 4 Sp Manual Transmission (vi/20)
iv/26/09 two:38pm
jp75vette
Sometime Member
Send Private Message
Bloomfield Hills, MI - USA
Vette(s):
1975 Corvette coupe, iv speed manual, 383 ci 9.5:1,Edelbrock dual plane Air Gap intake, Alum Heads,Comp Cam, roller Rockers, PS,PB,Tilt
Joined: 6/29/2008
Posts: 199
Ok , I rebuilt the manual over the wintertime, new bearings and syncros and sliders. Transmission is back in and the good news is that I now have third gear dorsum. In the past I could never shift into 3rd gear. I have a temporary eBay CPlus shifter in as the original went to Hurst for rebuild, just that takes 8 weeks.
The consequence is that at that place is some kind of ticking racket near the bell housing. I drove the machine effectually the cake and all gears work OK, but there is a ticking racket. The noise is also there when the car is stopped and running in neutral and also with the clutch in.
The auto is back on stands as now I need to find out where the ticking comes from.
Anyone accept whatsoever ideas?
What'southward Required to Remove iv Sp Transmission Transmission (7/twenty)
7/25/09 viii:17pm
Hopefully yous replaced the clutch, pressure plate, release bearing, pilot begetting/bushing and resurfaced the flywheel. If y'all did jot do all suggested, the ticking is volition exist solved when you lot remove the transmission and accomplish all of the to a higher place. Good luck.
______________
C3VR Life Fellow member #4
NCM Life Member #994
Vietnam Helicopter Pilots Association Life Member
What's Required to Remove 4 Sp Manual Transmission (viii/xx)
7/26/09 8:54am
jp75vette
Quondam Member
Send Private Message
Bloomfield Hills, MI - The states
Vette(due south):
1975 Corvette coupe, 4 speed manual, 383 ci 9.five:1,Edelbrock dual plane Air Gap intake, Alum Heads,Comp Cam, roller Rockers, PS,Pb,Tilt
Joined: half-dozen/29/2008
Posts: 199
I replaced the clutch, force per unit area plate, pilot bearing and resurfcd the flywheel.
The transmission did shift into 3rd for a wile and now does non. I am not sure if the alignment is OK or not. I as well take a vibration at 2500-3550 and it;due south likely clutch related. It'southward a real pain.
No time to work on it as I'chiliad in China for 5 weeks now. Machine is on jacks to get the brakes redone when I get habitation.
Always projects on these C3's; but that is part of the enjoyment.
Right at present I'm happy having 3 of the 4 gears.
What's Required to Remove 4 Sp Manual Transmission (9/20)
7/31/09 10:56pm
rick jay
Former Member
Send Private Message
Liverpool, NY - United states of america
Vette(s):
72 coupe, 350 4 spd, modified motor, exhaust, tires & wheels. '91 ZR1, modified frazzle.
Joined: 1/21/2003
Posts: 82
Don't take this the wrong mode, but what kind of clutch is it and which style did you lot install it? From what you wrote in, information technology sounds similar you lot covered everything else. Vibration? That'due south gotta be something not balanced or misalligned. Could the end of the trans shaft be as well long and pressing against the crank? When the flywheel was resurfaced, did they also cheque it for residual?
Proficient luck.
What'south Required to Remove 4 Sp Transmission Transmission (10/twenty)
11/26/09 12:11pm
jp75vette
Former Member
Ship Private Message
Bloomfield Hills, MI - USA
Vette(s):
1975 Corvette coupe, 4 speed transmission, 383 ci 9.5:1,Edelbrock dual plane Air Gap intake, Alum Heads,Comp Cam, roller Rockers, PS,PB,Tilt
Joined: 6/29/2008
Posts: 199
Finally solved the mystery of no 3rd gear. I adapted the travel of the rod by two turns and now I have third gear.
Our Sponsors help back up C3VR
Official C3 Vette Registry Community:
Domicile | Forums | Electronic mail | Who's Online
Clubs | Events | Member Stats
Other Official C3 Vette Registry Areas:
Members | Research | Shop
My Account | About C3VR
Other Official Vette Registry Sites:
C4 Vette Registry | C6 Vette Registry
Observe united states of america on Facebook
Corvette is a registered trademark of the General Motors Corporation(GM) & Chevrolet Motor Division. Vette Registries, LLC is responsible for all site content (except for member submitted content or where otherwise noted) and does non claim or imply that Chevrolet or GM is responsible for Official C3 Vette Registry content. Vette Registries, LLC is independent from GM and is not affiliated with, sponsored or supported past GM. Copyright/trademark/sales mark infringements are non intended, or implied and are in fact used to back up GM, Chevrolet and Corvette. Official C3 Vette Registry content is Copyright 2001-2022, Vette Registries, LLC. Content may not be reused without written consent. All Rights Reserved. NS
Corvette (Vette) Model Years on this site: 1968 1969 1970 1971 1972 1973 1974 1975 1976 1977 1978 1979 1980 1981 1982
Source: https://www.c3vr.com/vrforums/whats-required-to-remove-4-sp-manual-transmission_message332310.html
Posted by: weathersdideenable1961.blogspot.com
0 Response to "How To Remove A Manual Transmission"
Post a Comment